How to install the stair sensor light?

Stair sensor lamp installation method

1, first to measure the length of the step, width and channel lights and other dimensions. Start by taking it from the projection floor in the corner, extending the main line down the steps to the bottom step. RVB2 x 0.75 or 2 x 0.5 power cable is recommended.

2. Place the cut step bar on the step, and then open the hole on the step bar according to the step. The number of holes is determined according to the actual situation, the more the more firm, the step of about 1 meter is installed about 3 screws, and the step greater than 1.2 meters is generally installed in 4 screws.

3, put the expansion plug into the screw hole, and then choose self-tapping screws to fix the step bar well.

4. Connect the light belt wire, and then place the light belt into the light belt groove of the step bar. At this time, note that the light belt wire head is in accordance with the line groove of the block head, and can not be pressed by the position of the block head, otherwise it is easy to break the line. Install the lamp strip on the steps of the aluminum profile, and then place the aluminum profile into the steps.

5. Place the led light plate in the stop head and connect the power cord with the main line. If there is an led sign on the other side of the step, just use a main line and install it on the side of the sign; If there are led lights on both sides of the step, it is recommended to use the main line on both sides or connect the power line on both sides, and the led lights on the left (right) side are connected to the main line on the other side through the = light belt.

6. Connect the wires of the left and right resistance heads and place them on both sides of the step bar. Put the main line into the wire slot of the stop head, and then put the expansion plug in the position of the screw hole of the stop head, and then use the self-tapping screw to fix the main line.

7, high and low lapping installation horizontal and vertical sides, the main line should be hidden between the high and low lapping, but also pay special attention to the high and low lapping gap can not be too large.

8. Install the entire stair step block and step bar according to the installation method of the above stair sensor light, and then install the block cover plate with or without a number together.