How to use solar street lamp remote control?

Solar street light remote control is a device used to control solar street light, through the remote control can easily switch the solar street light, brightness adjustment and other operations. The following is the use of solar street lamp remote control.

1, ensure that the solar street lights have been installed and connected to the power supply. Then, install the battery of the solar street lamp remote control, usually open the battery cover, put the battery correctly in the battery slot, and then cover the battery.

2, turn on the power switch of the solar street lamp remote control, usually there is a switch button on the side or bottom of the remote control to turn it on. At this point, the indicator light of the remote control should light up, indicating that the remote control is already in the working state.

3, according to the specific function of the solar street lamp, use the button on the remote control to carry out the corresponding operation. In general, the solar street lamp remote control will have a switch button, brightness adjustment button and so on. By pressing the switch button, you can achieve the switch operation of the solar street lamp, press the brightness adjustment button, you can adjust the brightness of the solar street lamp.

When using the remote control, the following points need to be noted.

1, ensure that the distance between the remote control and the solar street lamp is not too far, in general, the distance is more appropriate within 10 meters.

2, the remote control indicator light should flash when pressing the button, indicating that the remote control is sending a signal to the solar street light. If the indicator light does not turn on or stays on, the battery may be low and needs to be replaced.

3, after use, remember to turn off the power switch of the solar street lamp remote control to save the battery life.

In general, the use of the solar street lamp remote control is relatively simple, only need to install the battery, turn on the power switch, press the corresponding button to achieve the control of the solar street lamp. When using, you need to pay attention to the distance and battery power to ensure the normal operation of the remote control.