There are steps to install wall lamps, how to install wall lamps on the wall?

Many families now use wall lamps in home decoration, most wall lamps installed in stairs, balconies, bedrooms, living room walls, corridors, etc., as decoration and long-term lighting, wall lamps can not be blindly installed, it is necessary to master certain necessities and needs in the room, decoration and coordination, then how to install wall lamps on the wall?

Method for installing and fixing wall lamps

 

Many professional lighting lamps may not know how to install and fix the wall lamp on the wall, in fact, the method of installing the wall lamp on the wall is very simple, first of all, determine the installation position of the wall lamp, and then install the water power supply in advance, and then fix the power cord installed on the wall lamp through the embedded parts or perforations, and then connect to the power supply. Finally, fix the wall lamp on the wall surface.

 

The following describes the manufacturing process of the wall lamp:

 

1. Roller coating method

The lower part of the rubber roller is immersed in the glue, and the upper part is exposed directly or indirectly through the printing roller, which is in contact with the working surface. The rubber roller is applied by rotation of the workpiece, etc., and the glue is stuck on the adhesive surface. In order to achieve different gluing effects, the surface of the rubber roller can be opened with different grooves and patterns, and the pressure of the rubber roller can be changed or the amount of glue applied can be controlled by using a scraper. Rubber rollers can be made of rubber, wood, felt or metal.

 

2. Brush method

Applying the adhesive to the bonded surface with a brush is the simplest and most common method, which is suitable for single or small batch production and construction.

 

3. Scratch coating method

For high viscosity limb like and paste adhesives and for bonding components such as floors, rubberized sheets can be applied, and rubber sheets can be made of materials such as elastic steel plates 1 to 1.5mm thick or rigid polyvinyl chloride plates.

 

4. Spraying method

For low viscosity adhesives, you can use an ordinary spray gun for spraying, for high viscosity adhesives with short working cycles and difficult to clean, you can use an enhanced spray gun from the reinforced plastics industry, the advantages of the spraying method are uniform coating and high working efficiency; The disadvantage is that the glue loss is very large (about 20% to 40%), and the solvent is lost in the air to pollute the environment.

 

5. Artesian method

The rainwater automatic device is used, the method is very suitable for flat parts, and the versatility is high, suitable for large-scale production, in order to make the glue will not block the nozzle, the glue used must have the appropriate viscosity and flow.

 

Wall lamp installation procedure

 

1. Determine the installation position: the installation height of the wall lamp should be slightly higher than the eye level, about 1.8 Michael;

2. Fixed lamp holder: First take out the bracket and mark it on the wall, then use the method of embedding or punching, and then insert the expansion tube with the screw to fix the bracket.

3. Connect the light bulb wire: Connect the light bulb to the line, but be careful not to touch the position of the wire during the operation.