What is the step light and what is the installation method?

Step lights are actually very common in our lives and are often seen in some entertainment venues. A step light is a string of lights on a staircase. Just turn on the switch that controls the light, and each step light strip will light up. This step light not only looks beautiful and beautiful, but also uses no electricity. It is a very good decoration and lighting.

Installation method of step light:

1. Different step lights are installed in different ways. If it is a long step lamp, you can directly use a fixed clip or double-sided tape, glass glue, etc. Attach it directly to the steps and you can use it normally. In general, it is recommended to use step lights to fix the step light strip, which is more beautiful. If it's an invisible step light, it's actually very simple. It means you need to install light strips under the steps. Then secure it with wood, steel, or floor.

2. If it is a step light installed at home, be sure to leave the hole for installing the step light first, and then tie the sample light belt to make it brighter. General use of cotton and hemp material is also a good choice.

3. The following tools are available: 6mm hammer drill, 6mm plastic expansion bolt, waterproof tape, wire stripper, hand drill, hammer drill, and 5cm long countersink tapping nails. When installing the step light, it can be installed with countersunk screws for safety. In some special cases, you may need to use a cutting machine.

4. Select the profile of the corresponding step size, and then put the step light on the left and right plugs at both ends of the profile, and then press the profile on the step with a 6mm hammer drill, open a hole every 20cm, plug the hole on the selected profile, and finally drive the 6mm plastic expansion bolt into it, and then lock the profile with countersink screws.

5. Next, cut the high and low strips according to the good size, and cut the holes after cutting. When installing the profile, make the layering edge, cover the upper side of the step with PVC leather, and then cover the upper layering fracture with a stopper. Note that the outer side of the batten is flush with the plug port. When the fixed batten base is not on the cover plate, it must be wired first.

6. Connect the step light to the main line first, and then the line follows the position in the high and low batten, and the cover of the batten is covered. Then connect the step light strip to the connector, first cut the excess plastic on both sides of the step light strip, and then insert the light strip into the connector. Be careful not to bend the lamp strip, because there is a circuit inside, so as not to affect the use of. Then connect the main line to the light bar of the cable head. If there are any row lights, they will be connected at this time. Finally, secure the plugs on both sides of the step light. If there is a sign, put it in the number plate and cover it with a clear lid. If there is no number, directly cover the black cover.